Rohde & Schwarz SMBV100B - Page 731

Remote Control Commands
R&S
®
SMBV100B
729User Manual 1178.4460.02 ─ 03
Parameters:
<Mode> CLISt | PULSe | PATTern | RATio
CLISt
A marker signal that is defined in the selected control list is gen-
erated.
*RST: RATio
Example: See Example "Adjusting clock, marker and trigger settings"
on page 713
Manual operation: See "Marker Mode" on page 114
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:ONTime
<OnTime>
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:OFFTime <OffTime>
Sets the number of symbols in a period (ON time + OFF time) for marker RATio.
Parameters:
<OffTime> integer
Range: 1 to 16777215
*RST: 1
Default unit: symbol
Example: See Example "Adjusting clock, marker and trigger settings"
on page 713
Manual operation: See "Marker Mode" on page 114
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:PATTern <Pattern>, <BitCount>
Defines the bit pattern used to generate the marker signal.
Parameters:
<Pattern> numeric
*RST: #H2
<BitCount> integer
0 = marker off, 1 = marker on
Range: 1 to 64
*RST: 2
Example: See Example "Adjusting clock, marker and trigger settings"
on page 713.
Manual operation: See "Marker Mode" on page 114
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:PULSe:DIVider <Divider>
Sets the divider for pulse marker mode (PULSe).
SOURce Subsystem