Remote Control Commands
R&S
®
SMBV100B
734User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:BB:DM:FLISt:POINts?
[:SOURce<hw>]:BB:DM:MLISt:POINts?
Queries the user modulation mapping/user filter list length.
Return values:
<Points> integer
Range: max
*RST: 0
Example:
BB:DM:FORM USER
BB:DM:MLIS:POIN?
Usage: Query only
[:SOURce<hw>]:BB:DM:CLISt:COPY <Filename>
[:SOURce<hw>]:BB:DM:DLISt:COPY <Filename>
Copies the selected data list (*.dm_iqd)/ control list (*.dm_iqc) as a new list with
name specified by <Filename>. If a list with the specified name exists, it is overwrit-
ten. If it does not yet exist, it is created.
The source file has to be available in the default directory (see :MMEMory:
CDIRectory) .
Refer to Chapter 12.6.2, "Accessing Files in the Default or in a Specified Directory",
on page 618 for general information on file handling in the default and a specific direc-
tory.
Setting parameters:
<Filename> string
Example: See Example "Performing general tasks" on page 712
Usage: Setting only
Manual operation: See "Select Data List" on page 121
[:SOURce<hw>]:BB:DM:CLISt:DATA <Data>
Sends the data to the currently selected control list. If the list already contains data, it is
overwritten. This command only writes data into the data section of the file.
The values for the control signals are sent, arranged in an 8-bit value as defined in
Table 12-1.
Table 12-1: Contents of a control lists
Signal Order Decimal value of bits
Marker 1
Marker 2
Marker 3
LSB 1
2
4
Burst LSB 16
SOURce Subsystem
To Next Page
Loading...
