Rohde & Schwarz SMBV100B - Page 821

Remote Control Commands
R&S
®
SMBV100B
819User Manual 1178.4460.02 ─ 03
The value selected here is used also as optimization mode in the I/Q modulator, and
vice versa.
For details, see R&S SMBV100B User Manual.
Parameters:
<FreqRespOptMode> FAST | QHIGh
FAST
Optimization by compensation for I/Q skew.
QHIGh
Optimization by compensation for I/Q skew and frequency
response correction.
This mode interrupts the RF signal. Do not use it in combination
with the uninterrupted level settings and strictly monotone
modes RF level modes
*RST: FAST
Example: See Example "Enabling high-quality optimization" on page 818.
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:BANDwidth:MODE
<FreqRespOptBwMo>
For [:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:MODE
QHIG|QHT, sets how the signal bandwidth is estimated: automatically or manually with
the command [:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:
BANDwidth[:VALue].
Parameters:
<FreqRespOptBwMo>AUTO | MANual
*RST: AUTO
Example: See Example "Enabling high-quality optimization" on page 818.
Manual operation: See "Optimization Bandwidth" on page 283
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:BANDwidth[:VALue]
<FreqRespOptBwVa>
Sets the signal compensation bandwidth for [:SOURce<hw>]:CORRection:
FRESponse:RF:OPTimization:BANDwidth:MODEMAN.
Parameters:
<FreqRespOptBwVa> integer
Range: depends on options to depends on options
*RST: depends on options
Example: See Example "Enabling high-quality optimization" on page 818.
Manual operation: See "Bandwidth" on page 283
SOURce Subsystem