Scanlab RTC6 PCIe Board - Page 974

RTC6 boards
Doc. Rev. 1.0.21 en-US
20 Appendix E: iDRIVE Scan Systems – Control Commands and Signals Transmitted to RTC Boards
974
innovators for industry
Code
HIGH
(hex)
0A
As of scan system firmware  2078.
UpdatePermanentMemory
UpdatePermanentMemory causes the scan system to set the current servo behavior as the
startup behavior for subsequent restarts or resets.
See also Chapter 8.1.8 ”Configuring the Start Behavior”, page 223.
As of scan system firmware  5050.
Only excelliSCAN:
excelliSCAN scan heads do not support UpdatePermanentMemory.
Code
LOW
(hex)
00 Only allowed value.
Notice! Generic information. May be incomplete or even incorrect for your scan system.
Always consult the dedicated scan system manual!
Module Rev.1.0.4 en-US