RM0440 Rev 4 1035/2126
RM0440 High-resolution timer (HRTIM)
1083
Bits 31:18 Reserved, must be kept at reset value.
Bit 17 BMPER: Burst mode period interrupt flag
This bit is set by hardware when a single-shot burst mode operation is completed or at the end of a
burst mode period in continuous mode. It is cleared by software writing it at 1.
0: No burst mode period interrupt occurred
1: Burst mode period interrupt occurred
Bit 16 DLLRDY: DLL Ready Interrupt Flag
This bit is set by hardware when the DLL calibration is completed. It is cleared by software writing it
at 1.
0: No DLL calibration ready interrupt occurred
1: DLL calibration ready interrupt occurred
Bits 15:7 Reserved, must be kept at reset value.
Bit 6 FLT6: Fault 6 interrupt flag
Refer to FLT1 description.
Bit 5 SYSFLT: System fault interrupt flag
Refer to FLT1 description.
Bit 4 FLT5: Fault 5 interrupt flag
Refer to FLT1 description.
Bit 3 FLT4: Fault 4 interrupt flag
Refer to FLT1 description.
Bit 2 FLT3: Fault 3 interrupt flag
Refer to FLT1 description.
Bit 1 FLT2: Fault 2 interrupt flag
Refer to FLT1 description.
Bit 0 FLT1: Fault 1 interrupt flag
This bit is set by hardware when fault 1 event occurs. It is cleared by software writing it at 1.
0: No fault 1 interrupt occurred
1: Fault 1 interrupt occurred
To Next Page
Loading...
Need help?
General
