EasyManua.ls Logo

ZyXEL Communications MSC1000G - Page 156

ZyXEL Communications MSC1000G
1168 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 5 Alarm Screens
Management Switch Card User’s Guide
156
VDSL_TCA_UAS INFO X The UnAvailable Seconds (<value>)
within 15 minutes for the vtu(c or r) has
reached the threshold (<value>).
MAC_SPOOF Minor X X X A duplicated MAC address is detected in
two DSL subscriber lines.
VDSL_RATE_CHANGE INFO X The transmission rate of the vtu (c or r)
changed from <value> to <value>.
VDSL_TCA_CORRECT Minor *
A
The number of error blocks that can be
corrected within 15 minutes for the vtu(c
or r) has reached the threshold
(<value>).
VDSL_TCA_FAILINIT Minor * The initialization failures (<value>)
within 15 minutes for the vtu(c or r) has
reached the threshold (<value>).
VDSL_TCA_FEC Minor * The Forward Error Correction Seconds
(<value>) within 15 minutes for the
vtu(c or r) has reached the threshold
(<value>).
VDSL_STATUS_CHANGE Minor * The status of the VDSL line has changed.
LINE_LOOPGUARD Minor * A network loop has been detected.
Equipment
DC_POWER_FAIL CRITICAL X The -48VDC power -<index> failed.
VOLTAGE_ERROR CRITICAL X X X The voltage <index> at input <value> is
too low <value>, or high <value>.
TEMPERATURE_ERROR CRITICAL X X X The temperature <index> at input
<value> is too low <value> or high
<value>.
FAN_ERROR CRITICAL X The fan <index> speed <value> is too
low <value> or high <value>
FAN_STOP_LOW_TEMP MINOR X The fan stopped due to low temperature.
HW_MONITOR_FAIL CRITICAL X X A hardware monitor diagnosis test failed.
COLD_START INFO X System cold-start.
WARM_START INFO X System warm-start.
MGMT_ETHER_UP INFO X The management Ethernet interface is
up.
MGMT_ETHER_DOWN MINOR X The management Ethernet interface is
down.
ALARM_IN CRITICAL X External alarm on input <index>.
SPT_TOPOLOGY_CHANG MINOR X A spanning tree topology change was
detected.
NT_FW_UPLOAD_OK INFO X Firmware upload was successful.
NT_FW_UPLOAD_FAIL MAJOR X Firmware upload failed.
LT_PLUG_IN INFO X A line card was inserted into a slot.
LT_PULL_OUT MAJOR X A line card was removed from a slot.
LT_DSL_DEVICE_FAIL CRITICAL X A DSL chipset on an ALC failed.
LT_DSL_DEVICE_RELOAD INFO X A DSL chipset on an ALC re-downloaded
firmware <index>.
Table 60 Alarm Descriptions (continued)
ALARM SEVERITY MSC ALC SLC VLC VOP IMA DESCRIPTION

Table of Contents

Related product manuals