ZyXEL Communications MSC1000G - Page 770

Chapter 29 port Commands
Management Switch Card User’s Guide
770
limitmask set <slot-port>
<limitmask
Configures the PSD (Power Spectrum Density)
mask.
limitmask:
1: VDSL2_A_NUS0
2~11:
VDSL2_A_EU[32,36,40,44,48,52,56,60,64,128]
12: VDSL1_FTTEX_ANSI_M1
13: VDSL1_FTTEX_ANSI_M2
14: VDSL1_FTTCAB_ANSI_M1
15: VDSL1_FTTCAB_ANSI_M2
16: VDSL1_FTTEX_ANSI_M1_e
17: VDSL1_FTTEX_ANSI_M2_e
18: VDSL1_FTTCAB_ANSI_M1_e
19: VDSL1_FTTCAB_ANSI_M2_e
20: VDSL2_A_CT
21~36: VDSL2_B8_[1..16]
37~46: VDSL2_B7_[1..10]
47: VDSL2_BT_ANFP
48: VDSL2_C_138_b
49: VDSL2_C_276_b
50: VDSL2_C_138_co
51: VDSL2_C_276_co
Four additional customer-defined PSD shapes can
be configured per system.
8
optionmask <slot-port> <option-
mask>
Sets the advanced DSL physical layer settings for
optional band on a VDSL port
8
power <slot-port>
fix|power|rate
<max_us_tx>
<max_ds_tx>
<max_rx>
Specifies the maximum allowed transmission
power and maximum aggregate received power.
fix|power|rate: PSD and power adaptivity:
fix: fixed mode
power
: priority to power
rate: priority to rate
max_us_tx: maximum upstream transmission
power (-130~200 in 0.1 dBm).
max_ds_tx: maximum downstream transmit
power (-50~200 in 0.1 dBm).
max_rx: maximum aggregate receive power at
vtu-c (-255~255 in 0.1 dBm).
8
priority <slot-port>
<priority>
Sets the VDSL port(s) VLAN priority (0~7). 0 is the
lowest priority level and 7 is the highest.
8
Table 364 port Commands (continued)
COMMAND DESCRIPTION P