ZyXEL Communications MSC1000G - Page 771

Chapter 29 port Commands
Management Switch Card User’s Guide
771
pvid <slot-port> <vid>
Sets the port VID on the VDSL port(s). 8
pvlan delete <slot-port>
<etype>
Deletes a protocol VLAN setting on a specified port. 8
set <slot-port>
<etype> <vid>
<priority>
Sets the protocol VLAN settings on a specified port. 8
rfiband <slot-port>
<disable|ansi|etsi|c
ustom>
Selects an RFI band or disables this feature. 8
rficustom disable <index>
Displays the settings of a custom RFI entry. 8
enable <index>
Activates the specified custom RFI entry. 8
set <index>
<start_freq>
<stop_freq>
Sets a custom RFI entry.
index: 1~8
start_freq: The start of the frequency range in
kHz.
start_freq cannot be bigger than
stop_freq.
stop_freq: end of the frequency range in kHz.
8
show
Displays custom RFI settings. 1
set <slot-port> <profile>
<mode>|<pmask>
Sets the VDSL profile, mode, and mask on the
VDSL port(s).
mode: auto|8a|8b|8c|8d|12a|12b|17a|adsl2+|
vdsl2
pmask: 32 option bits, 0x00000001~0xffffffff,
0x00000001 G.992.1
0x00000002 G.992.2
0x00000004 G.992.3
0x00000010 G.992.5
0x00000020 ANSI T1.413
0x00000040 ETSI TS 101 388
0x00000080 G.993.2 8a
0x00000100 G.993.2 8b
0x00000200 G.993.2 8c
0x00000400 G.993.2 8d
0x00000800 G.993.2 12a
0x00001000 G.993.2 12b
0x00002000 G.993.2 17a
Note: The VLC1224G supports VDSL2 profile
modes 8a, 8b, 8c, 8d and 12a only.
8
Table 364 port Commands (continued)
COMMAND DESCRIPTION P