ZyXEL Communications MSC1000G - Page 843

Chapter 30 profile Commands
Management Switch Card User’s Guide
843
set <profile> atuc [lofs
<lofs>] [loss <loss>] [lols
<lols>]
[lprs <lprs>] [ess <ess>]
[ffr <ffr>] [sesl <sesl>]
[uasl <uasl>]
[fru <fru>] [iru <iru>]
[frd <frd>] [ird <ird>]
[ift <ift>]
or
<profile> atur [lofs
<lofs>] [loss <loss>] [lprs
<lprs>]
[ess <ess>] [sesl <sesl>]
[uasl <uasl>] [fru
<fru>][iru <iru>][frd
<frd>] [ird <ird>]
Creates a profile of ADSL alarm settings. 8
show [profile]
Lists the ADSL alarm profiles or a specific
profile’s settings.
1
alarmshds
l
delete <profile>
Removes an unreferenced SHDSL alarm
profile.
8
map <profile>
Displays which SHDSL ports reference this
alarm profile.
1
set <profile> [atten <atten>]
[snrmgn <snrmgn>] [es <es>]
[ses <ses>][crc <crc>]
[losws <losws>] [uas <uas>]
Creates a profile of SHDSL alarm settings.
atten: The loop attenuation threshold
(0~127).
snrmgn: The signal-to-noise (SNR)
margin threshold (0~15).
es: The maximum time for errors to occur
(0~900 seconds)
ses: The maximum time for severe errors
to occur (0~900 seconds)
crc: The maximum number (>=0) of
cyclic redundancy check (CRC) anomalies.
losws: The maximum time for sync word
loss to occur (0~900 seconds).
uas: The maximum number of unavailable
seconds (0~900).
8
show [profile]
Lists the SHDSL alarm profiles or a specific
alarm profile’s settings.
1
alarmadsl delete <profile>
Removes an unreferenced ADSL alarm
profile.
8
map <profile>
Displays which ADSL ports reference this
alarm profile.
1
Table 366 profile Commands (continued)
COMMAND DESCRIPTION P