ZyXEL Communications MSC1000G - Page 847

Chapter 30 profile Commands
Management Switch Card User’s Guide
847
show [<profile>]
Displays an alarm VDSL2 line profile. 1
template delete <profile>
Removes an alarm VDSL2 template. 8
map <profile>
Displays an alarm VDSL2 template’s
mappings.
8
set <name> <line-profile>
<chan-profile>
Creates an alarm VDSL2 template. 8
show [<profile>]
Displays an alarm VDSL2 template. 1
atm delete <profile>
Removes an unreferenced ATM traffic profile. 8
map <profile>
Displays which ports reference this ATM
profile.
1
set <atmprofile> cbr|ubr <pcr>
<cdvt>
or
<atmprofile> rt-vbr|nrt-vbr
<pcr> <cdvt> <scr> <bt>
Creates a profile of ATM traffic settings.
cbr: constant cell rate
ubr: unspecified cell rate
rt-vbr: real time variable bit rate
nrt-vbr: non-real time variable bit rate
pcr: peak cell rate (150~300000)
scr: sustainable cell rate, (150~300000)
cdvt: cell delay variation tolerance,
(0~255).
bt: burst tolerance (0~255).
Note: use “*” to set pcr, cdvt, scr and bt to
the default value.
8
show [<profile>]
Lists the ATM traffic profiles or a specific
profile’s settings.
1
igmpfilte
r
delete <igmpfilter>
Removes an unreferenced IGMP filter profile.
IGMP filter profiles allow you to control
access to IGMP multicast groups.
8
map <igmpfilter>
Displays which ports reference this IGMP
filter profile.
1
set <igmpfilter> <index>
<startip> <endip>
Creates an IGMP filter profile of ATM traffic
settings.
igmpfilter: profile name
index: index of addresses (1~128).
startip
: start of address range
endip: end of address range
8
show [igmpprofile]
Lists the IGMP filter profiles or a specific
profile’s settings.
1
ipqos delete <profile>
Deletes a specified IPQoS profile.
profile: The name of a QoS profile
configured using the profile command.
8
Table 366 profile Commands (continued)
COMMAND DESCRIPTION P