ZyXEL Communications MSC1000G - Page 855

Chapter 30 profile Commands
Management Switch Card User’s Guide
855
set <profile> <mgc-ip>|<mgc-dn>
[mgcport <mgc-port>][mgc2
off|{on <mgc2-ip>|<mgc2-
dn>}] [mgc2port <mgc2-
port>][transport
udp|tcp][encode
long|short][pbit
<pbit>][dscp <dscp>]
<profile> [it
<it>] [prefix <prefix>
<start-num> <suffix-len>]
[softswitch <softswitch>]
[vbd off|on] [rtpport
<start-rtp-port> <end-rtp-
port>][dmtimeout <start-
timeout> <short-timeout>
<long-timeout>] [retrantime
<init-retrantime> <min-
retrantime> <max-
retrantime> <retran-
window>] [rfc2833 off|{on
<payload-type>}] [t38
off|on] [forcever off|on]
Configures an H.248 profile.
See Section 30.20.3 on page 903 for more
information on this command.
The default H248 profile values are:
H248 profile : DEFVAL
mgc-dn : DEFVAL
mgc2-dn : DEFVAL
mgcport : 2944
mgc2port : 2944
mgc2Option : off
transport : udp
encode : long text
pbit : 7
dscp : 48
softswitch : DEFVAL
it : 0(10ms)
prefix : RTP/
start-num : 1
suffix-len : 0
vbd : off
start-rtp-port : 60000
end-rtp-port : 65000
start-timeout : 16(s)
short-timeout : 4(s)
long-timeout : 4(s)
init-retrantime : 2000(ms)
min-retrantime : 100(ms)
max-retrantime : 4000(ms)
retran-window : 25000(ms)
rfc2833 : off
t38 : off
forcever : off
8
show [profile]
Displays the settings of all H248 profiles or
the specified one.
1
voip sip callsvc
delete
<profile>
Removes the specified SIP call service
profile.
8
callsvc
map
<profile>
Displays the subscribers that reference the
specified call service profile.
1
Table 366 profile Commands (continued)
COMMAND DESCRIPTION P