ZyXEL Communications MSC1000G - Page 856

Chapter 30 profile Commands
Management Switch Card User’s Guide
856
callsvc
set
<name>
[keypattern <pattern-
table>]
[nopassword | {password
<password>}
[registration off|{on
[<re>]}]
[numberplan off|on {<cc>
<ndc> <numberplan-table>}]
[localhelp off|on {<tel-
number> <localhelp-table>
[<tel-number> <localhelp-
table>...]}]
[dnd on|off]
[dtmf
bypass|rfc2833|sipinfo|rfc2
833like|plaintext]
[callhold on|off]
[callwait on|off]
[callreturn on|off]
[cidcw on|off]
[clip on|off]
[clir on|off]
[calltransfer on|off]
[conference on|off]
[callsvcmode europe|usa]
[onhooktransfer on|off]
[conftransfer on|off]
[fax t38|g711]
[firstdigit
<fdt>][interdigit <idt>]
[flash
invite|rfc2833|rfc2833like|
sipinfo1|sipinfo2|sipinfo3|
sipinfo4|{sipinfo5 [<rc>]}|
For the G and GB models:
Configures a new call service profile.
keypattern: Enter the VoIP key pattern to
use.
Once the password configuration is set, it
cannot be changed.
nopassword: No password is needed for SIP
registration.
password: A password is needed for SIP
registration.
password: The SIP registration password
(maximum 32 characters).
registration: choose on and enter a time
period (<re>) to have the system use the
registration timeout feature. If the system
does not receive a registration confirmation
message from the SIP server in the time
specified, it drops the connection. Select off
to not use the registration timeout feature.
numberplan: Configures whether or not the
specified call service profile references a
numbering plan and, if so, which numbering
plan.
numberplan: Turn number plan on or off.
cc: Local country code. This defines the
digits the numbering plan inserts when a
rule contains “\c”.
ndc: Local national destination code. This
defines the digits the numbering plan inserts
when a rule contains “\d”.
numberplan-table: The name of the
numbering plan to use.
localhelp: Turn the local help table feature
on or off. Specify the name of the local help
table you want users to access when they
call a specific telephone number.
dnd: Turn Do not Disturb on or off.
bypass: Do not relay DTMF signals.
rfc2833: Sets the system to relay DTMF
tones according to RFC2833.
sipinfo: Sets the system to relay DTMF
signals via SIP INFO message.
rfc2833like: Sets the system to relay
DTMF signals via SIP INFO but carrying
RFC2833 payload.
8
Table 366 profile Commands (continued)
COMMAND DESCRIPTION P