ZyXEL Communications MSC1000G - Page 857

Chapter 30 profile Commands
Management Switch Card User’s Guide
857
{sipinfo6 [<si>]}
[localcall on|off]
[mwi on|off]
[reanswer <ra>]
For the G and GB models. Continued:
callhold: Turn call holding on or off.
callwait: Turn call waiting on or off.
callreturn: Turn call return on or off.
cidcw: Turn Calling Identity Delivery on Call
Waiting on or off.
clip: Turn Caller ID presentation on or off.
clir: Allows (on) or prohibits (off) caller ID
restriction.
calltransfer: Turn call transferring on or
off.
conference: Allows (on) or prohibits (off)
conference calls.
callsvcmode: Set supplementary phone
services to European or American mode.
g711: Relay fax signals via ITU-T G.711.
t38: Relay fax signals via ITU-T T.38.
firstdigit: Set the number of seconds a
person has to dial the first digit after taking
the phone off-hook.
interdigit: Set the number of seconds a
person has between dialing digits.
flash: Select the method for processing a
flash signal from a user.
invite: relay flash by SIP INVITE signal.
rfc2833: relay flash according to RFC 2833.
rfc2833like: relays flash in SIP INFO
packets, but carried as RFC 2833 payload
sipinfo1: relays flash in SIP INFO packets
(a signal=16 message)
sipinfo2: relays flash in SIP INFO packets
(a signal=hf message)
sipinfo3: relays flash in SIP INFO packets
(a signal=hook-flash message)
sipinfo4: relays flash in SIP INFO packets
(a plain text “FLASH” message).
sipinfo5: relays flash in SIP INFO packets
(multiple SIP messages). The message
content is determined by the characters you
enter for <rc>. A separate SIP INFO
message is sent for each character you
enter.
Table 366 profile Commands (continued)
COMMAND DESCRIPTION P