Chapter 30 profile Commands
Management Switch Card User’s Guide
914
This command creates and configures a SIP call service profile. The values of the default SIP call
service profile are as follows:
• Password: none.
• Key pattern table: DEFVAL
• Registration timeout: on 3600 seconds
•DND: on
• Call holding: on
• Call waiting: on
• Call return: on
•CLIP: on
callsvcmode
europe|usa
=
Set supplementary phone services to European (europe) or American (usa)
mode.
onhooktransfer =
This setting controls what happens when the initiator of a conference call
hangs up. Turn this on to have the conference call continue without the
initiator. Turn this off to have the conference call end with the initiator hangs
up.
conftransfer =
Turn this on to allow a subscriber to make a conference call and then
transfer the call.
fax g711 =
The system relays fax signals according to ITU-T G.711.
fax t38 =
The system relays fax signals according to ITU-T T-38.
firstdigit =
Set the number of seconds a person has to dial the first digit after taking the
phone off-hook.
interdigit =
Set the number of seconds a person has between dialing digits.
flash =
Select the method the system uses to process the flash signal from a user.
invite =
Relays flash by SIP INVITE signal.
rfc2833 =
Relays flash according to RFC 2833.
rfc2833like =
Relays flash in SIP INFO packets, but carried as RFC 2833 payload
sipinfo1 =
Relays flash in SIP INFO packets (a signal=16 message)
sipinfo2 =
Relays flash in SIP INFO packets (a signal=hf message)
sipinfo3 =
Relays flash in SIP INFO packets (a signal=hook-flash message)
sipinfo4 =
Relays flash in SIP INFO packets (a plain text “FLASH” message).
sipinfo5 =
Relays flash in SIP INFO packets (multiple SIP messages). The message
content is determined by the characters you enter for <rc>. A separate SIP
INFO message is sent for each character you enter.
sipinfo6 =
Relays flash in SIP INFO packets (where the content of the message is
determined by the text you enter for <si>).
localcall =
Sets whether or not to allow subscribers to call other subscribers if the
system’s connection to the SIP server is not available.
mwi =
Turns the message waiting indicator on or off.
reanswer =
When the system is using v5sip mode, use this field to set the reanswer time
period. The reanswer time controls the length of time between the user
hanging up the phone, and the call being disconnected (the BYE request
being sent).
ra =
The reanswer time period in seconds (0-30) after the user hangs up the
phone before disconnecting the call.
To Next Page
Loading...
