ZyXEL Communications MSC1000G - Page 990

Chapter 33 switch Commands
Management Switch Card User’s Guide
990
qschedule set <giga-port> spq
or
<giga-port> wrr
<wt0> <wt1> <wt2>
<wt3> <wt4> <wt5>
<wt6> <wt7>
Sets a port’s queuing method and/or priority
weight.
spq: strict priority queuing algorithm
wrr: weighted round robin queue algorithm
wt0~wt7: priority weight, 0~15
8
show
Displays the queuing settings. 1
queuemap set <priority> <queue>
Sets a queue’s priority. 8
show
Displays the queues’ priorities. 1
sfp rxpower <giga-
port>|<slot-port>
<high-limit> <low-
limit>
Sets a transceiver’s receiving power thresholds.
When the received power goes out of the
thresholds, the system sends an alarm.
giga-port: enetx where x=1~6
slot-port: Only the VLC13xx supports the
switch sfp commands.
high-limit: high threshold, 0 ~ 6553.5
low-limit: low threshold, 0 ~ 6553.5. the value
must be smaller than the high-limit value.
8
show <slot>|<slot-
port>|<giga-port>
Displays transceiver’s receiving power thresholds
of a slot or a port.
8
temperature <giga-
port>|<slot-port>
<high-limit> <low-
limit>
Sets a transceiver’s temperature thresholds.
When the temperature goes out of the thresholds,
the system sends an alarm.
high-limit: high threshold, -128~127.9 in
centigrade (°C).
low-limit: low threshold, -128~127.9 in
centigrade (°C). The value must be smaller than
the high-limit value.
8
txbias <giga-
port>|<slot-port>
<high-limit> <low-
limit>
Sets a transceiver’s laser bias current thresholds.
When the value goes out of the thresholds, the
system sends an alarm.
Sets an SFP slot’s current in milliamps (mA) in a
range.
high-limit: high threshold, 0~131.07
low-limit: low threshold, 0~131.07. The value
must be smaller than the high-limit value.
8
txpower <giga-
port>|<slot-port>
<high-limit> <low-
limit>
Sets a transceiver’s transmitting power
thresholds. When the value goes out of the
thresholds, the system sends an alarm.
high-limit: high threshold, 0~6553.5
low-limit: low threshold, 0~6553.5. The value
must be smaller than the high-limit value.
8
Table 386 switch Commands (continued)
COMMAND DESCRIPTION P