05/2014
6-221
DC SC2020
General
6.4.10 Installation Settings
Version 1.1
Figure 2 j0bs64059
3. Press the [<--] (Back) button to return to the [Printer Diag] screen.
Figure 3 j0bs64058
4. Exit the CE mode. (See "6.4.4 How to Exit the CE Mode".)
6.4.10 Installation Settings
Display/set/clear the following parameter.
Depending on the item, it can be displayed/set, only to display, or only to clear.
Table 1 Installatin Settings
Item Range Description
Serial No.1 9 digits Displays or changes the 9 digits serial number.
Serial No.2
Serial No.3
Product No.1
Product No.2
Product No.3
HexDump ON,OFF Specifies whether HexDump to set to ON or
OFF.
Tone Correction (IOT
tone control)
ON,OFF Specifies whether IOT Tone Correction to set
to ON or OFF.
Pixel Counter 0-100% Displays the last print pixel coverage (%) for
4mm square meter in A4 paper, per Y/M/C/K
color.
Configuration Dip Switch 0 - Operates the DIP switches on the NVM in ESS.
Dip Switch 1
Dip Switch 2
Dip Switch 3
Meter Type Type1~5 Displays the current setup information of the
meter type
Print Counter
(Print Service)
Full Color Displays the current count of the following.- Normal Full Color
Print Count
Color1 Displays the current count of the following.- Toner Saver Print
Count
Color2 Displays the current count of the following.- Specific Color
Print Count
B/W Displays the current count of the following.- Normal Mono-
chrome Print Count- Toner Saver Monochrome Print Count-
Report Print Count
Total Displays the total count of the full color print and themono-
chrome print.
Full Color
Backup
Displays the current count of the following.- Full Color Print
Count Backup
Color1 Backup Displays the count backup of the following.- Toner Saver Print
Count Backup
Color2 Backup Displays the count backup of the following.- Specific Color
Print Count Backup
B/W Backup Displays the count backup of the monochrome print.
To Next Page
Loading...
Need help?
General
