05/2014
6-223
DC SC2020
General
6.4.10 Installation Settings
Version 1.1
6.4.10.1 Serial No. setting (Serial No.)
Shows the serial number setting operation procedure as an example.
1. Enter the CE Mode. (Refer to "6.4.2 How to Enter the CE Mode")
2. Make sure [Printer Diag] is selected, and then press [OK] button.
3. Select "Installation" in the [Down arrow] button, and then press [OK] button.
Figure 1 j0bs64100
4. Press the [OK] button.
Figure 2 j0bs64101
5. Change the serial number.
• [Move the Cursor (A) to the left or the right by pressing the [<] [>] buttons.
• Change the number of the cursor (A) by pressing the [Up arrow] button and [Down arrow] but-
ton.
• If you have changed the value, * mark disappears, it indicates serial number current value has
changed.
Figure 3 j0bs64061
6. Press the [OK] button.
• The modified value is written, return to the previous screen.
Clear Device Data - Erasing the following data
• Error Log data in EEPROM
• Jam Log data in EEPROM
• Job Log data in EEPROM
• FW Parameter data in EEPROM
• NET Parameter data in EEPROM
• Auditron in EEPROM/ Print Volume data
per user
•MRAM Adr
•FAX Log
Table 1 Installatin Settings
Item Range Description
To Next Page
Loading...
Need help?
General
