Fuji Xerox DocuCentre SC2020 - Page 622

05/2014
6-224
DC SC2020
6.4.10 Installation Settings
Version 1.1
General
Figure 4 j0bs64062
7. Press the [<--] (Back) button to return to the [Printer Diag] screen.
Figure 5 j0bs64063
8. Exit the CE mode. (See "6.4.4 How to Exit the CE Mode".)
6.4.10.2 Copy Counter M to B/Copy Counter B to M
1. Copy Counter M to B
• Copies data from Master NVM of ESS to the Backup NVM.
2. Copy Counter B to M
• Copies data from Backup NVM of ESS to the Master NVM.
For example, here is the operating procedure of "Copy Counter M to B".
1. Enter the CE Mode. (Refer to "6.4.2 How to Enter the CE Mode")
2. Make sure [Printer Diag] is selected, and then press [OK] button.
3. Select "Installation" in the [Down arrow] button, and then press [OK] button.
Figure 6 j0bs64100
4. Select "Copy Counter M to B" in the [Down arrow] button, and then press [OK] button.
Figure 7 j0bs64176
5. Press the [OK] button.
Figure 8 j0bs64177
6. Copy is started by pressing the [OK] button, the following screen is displayed when you exit.