Konica Minolta CS-7 - Exposure Procedure with CR Cassette

109
Chapter 5
5.4.1 Exposure ow
The following describes the ow of basic exposure using CR cassette. See each item for detailed procedures.
5.4.5 Exposure ……………………………… (4)
5.4.4 Manual body part selection ………… (3)
● Exposure with specied reading sequence ……(6)● Exposure with bar code registration …… (5)
5.4.7 Examination completion and output … (8)
5.4.6 Image adjustment of the exposure screen … (7)
5.4.3 Selection of examination ……(2)
5.4.2 New registration of patient information … (1)
Number Task
(1)
Perform a new patient registration in the patient registration screen.
(2) Select the examination target in the list screen.
(3) Perform exposure with the CR cassette.
(4) Set the exposure body part and exposure condition.
(5) Perform exposure with bar code registration. Perform bar code registration on the exposure screen.
(6) Perform exposure with a specied reading sequence. Specify the reading sequence on the exposure screen.
(7)
After exposure and reading the CR cassette with REGIUS or REGIUS SIGMA/SIGMA2, adjust the exposed image.
Change the S value/G value, move the ROI area, etc.
(8)
When all exposures are nished, the examination is completed. Image is simultaneously and automatically output upon
examination completion. (depending on the settings)
5.4 Exposure with CR cassette