Konica Minolta CS-7 - Ending the Checkup Mode

335
7.18 Checkup mode
Chapter 7
1
Carry out bar code scanning on the pa-
tient registration screen to scan the pa-
tient ID or accession number.
• An examination starts automatically.
2
Perform exposure.
• Set up the X-ray device and check the exposure
settings before performing exposure.
Press the exposure switch
3
Press [ ].
• The patient registration screen is displayed.
HINT
•••••••••••••••••••••••••••••••••••••
• The serial number displayed before bar code scan-
ning was carried out is input to the patient registration
screen.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
7.18.7 Ending the checkup
mode
End the checkup mode.
Here, the procedure when automatic checkup is on
is described. When automatic checkup is o󰀨, refer to
step 3.
1
Press [ ] on the exposure screen.
• Press [ ] while nothing is being exposed.
• A confirmation message to end the checkup is
displayed.