Konica Minolta CS-7 - Additional Exposure in; The Multi-Study

299
7.12 Multi-study
Chapter 7
7.12.4 Additional exposure in
the multi-study
The following describes how to add exposures to the
examination item.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• The maximum number of exposures that can be ac-
quired, including examinations which have already
been started with exposed images, is 512. If the total
number of exposures surpasses 512, an error message
is displayed.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
1
Press [Add Study] on the exposure screen
([Study List] tab screen).
• The Body part selection screen is displayed.
2
Select the body part targeted for exposure.
• For the body part selection procedure, refer to
"5.2.4 Manual body part selection".
HINT
•••••••••••••••••••••••••••••••••••••
• You can issue the accession number by pressing [Is-
sue].
•••••••••••••••••••••••••••••••••••••••••••••••••••••
10
Press the second examination.
• When there are two or more exposure items,
press the intended examination and proceed
with the exposure using the same procedure.
• Exposure screen ([Exam.Tag] tab screen) is dis-
played.
• Continue with your exposure using the proce-
dures described in Steps 5 to 8.
11
Once all the examinations are finished,
press [
].
• The display returns to the initial screen.
HINT
•••••••••••••••••••••••••••••••••••••
• Exposures can be added or deleted even after switch-
ing to the body part selection screen.
• In case of the automatic 1×1 display screen, next ex-
posure can be displayed by pressing [NEXT] displayed
in the Exam. Tags display area after completing the
exposure of 1 examination.
•••••••••••••••••••••••••••••••••••••••••••••••••••••