Konica Minolta CS-7 - Understanding the Manual Structure

14
Introduction
Structure of pages
00
1.1 OperationFlow
1.1.1 Displayingtheexposure
screen
Perform the following procedure when to display the
exposure screen.
1
 Turn on thepowerforX-raydevices,etc.
connectedtothisdevice.
2
 Pressthepowerswitchonthisdevice.
• Startup messages are displayed sequentially.
• Internal system initialization is performed while
the system startup screen is displayed.
• Upon completion of initialization, the initial
screen (list screen) is displayed.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• When sharing a REGIUS among several units of this
device, start the unit with the JM installed first; after
conrming startup of this unit, start the other units.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT
•••••••••••••••••••••••••••••••••••••
• The software version is displayed on the system
startup screen. Initialization will be completed a few
minutes after turning on the power.
• A progress bar is displayed on the system startup
screen, indicating the status of the system initialization
process.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
3
 Selecttheexaminationtarget.
• The examination is selected.
4
Press[Perform].
• The exposure screen is displayed
.
Exampleofpagestructure
(1)
(2)
(3)
(4)
(5)
Number Item Description Icon
(1) Item heading
Describes the titles of described content. -
(2) Operation procedure
The operating procedure is described in sequential numerical
steps.
-
(3) Screen display
Shows a screen on which operations are performed. -
(4) Important items
Describes important items for operation. Be sure to read them.
IMPORTANT
(5) Hint Describes important information.
HINT