Konica Minolta CS-7 - Change of Serial Numbers and Presets; Presets

333
7.18 Checkup mode
Chapter 7
7.18.5 Change of serial
numbers and presets
To change the serial number and preset during expo-
sure, perform the following procedure.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• The following functions cannot be used when the
checkup setting screen is displayed from the exposure
screen.
– Turns the checkup mode [ON] and [OFF].
– Turns the daily reset function [ON] and [OFF].
– Turns the auto examination start function [ON] and
[OFF].
– Switching to the checkup preset setting screen
– [Delete], [Copy], and [Setting] operations
•••••••••••••••••••••••••••••••••••••••••••••••••••••
z
Change of serial numbers
1
Press [Patient Info] on the exposure
screen.
• The checkup setting screen is displayed.
2
Change the serial number using the [▲]
and [▼] buttons in the serial number dis-
play eld.
3
Press [OK].
• The patient information is updated.
HINT
•••••••••••••••••••••••••••••••••••••
• When the examination of the changed serial number
is completed, the process continues and starts the
examination with the next serial number. For example,
if the serial number is changed from "001" to "010"
before the examination is nished, the serial number
shifts to the next number, "011". If "011" has already
been exposed, the serial number shifts to "012", the
next number.
•••••••••••••••••••••••••••••••••••••••••••••••••••••