Konica Minolta CS-7 - Page 332

332
7.18 Checkup mode
3
Select the exposure body part.
HINT
•••••••••••••••••••••••••••••••••••••
• Press [Return] to return the display to the initial
screen. In this case, the issued number remains the
same.
• If you press [Schedule], the number is saved and the
display returns to the initial screen. In this case, a next
number is automatically issued.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
4
Press [Perform].
• The exposure screen is displayed.
• The selected body part targeted for exposure is
displayed.
5
Perform exposure.
• Configure the X-ray device settings and check
the exposure setting before making an expo-
sure.
Press the exposure switch
6
Press [ ].
• The display returns to the initial screen with the
next numbers displayed on it.
• Repeat Steps 1 to 6 to continue your exposure.
HINT
•••••••••••••••••••••••••••••••••••••
• When [Auto Checkup] is turned [ON], the display re-
turns to the Body part selection screen rather than the
initial screen.
•••••••••••••••••••••••••••••••••••••••••••••••••••••