Konica Minolta CS-7 - Exposure Preparations

235
7.4 Exposure with Unitless
Chapter 7
7.4.2 Exposure preparations
Make the following preparations when exposing using
unitless. The following procedure is for an example in
which a wired connection is in operation between this
device and a higher system.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• When this device is being used in unitless, charge it
when a notication that the battery level is low is dis-
played.
• Check the settings for the AeroSync button, and initial
detection level on the system monitor screen.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
1
Register the DR Detector in this device
that is to be used in unitless.
• For operation of the DR Detector, refer to
"AeroDR Operation Manual".
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• When an DR Detector which does not support Aero
Sync mode is used, an error message appears and
registration will not be permitted.
• The communication speed may be reduced when DR
Detector images are transmitted simultaneously with
host output.
If the communication speed is reduced, make sure
there are no output reservations on the system moni-
tor screen (system monitor tab) and then turn o󰀨 host
output. After all examinations are complete, turn host
output back on.
The device switches between [ON] and [OFF] every
time [Output] is pressed.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
2
Import the examination information to be
used for the exposure using the portable
X-ray device.
• Conrm that an Ethernet cable is connected to
this device.
• Press [Refresh] on the list screen on this device.
• The latest examination information is imported
from the higher system by pressing the [Refresh]
button.
HINT
•••••••••••••••••••••••••••••••••••••
• To input examination information manually, change the
screen to the patient registration screen.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
3
Remove the Ethernet cable connected to
the DR Detector registration side hub from
this device.
4
Unplug the power cable from the outlet
when charging this device.
5
Complete the exposure preparations.
HINT
•••••••••••••••••••••••••••••••••••••
• It is all right to keep power of this device and the DR
Detector on.
•••••••••••••••••••••••••••••••••••••••••••••••••••••