Konica Minolta CS-7 - Automatic 1×1 Display Function

157
Chapter 6
6.4 Functions of the exposure screen
z
Select the output of highlighted tube/gauze
image
Switch the output settings of highlighted tube/gauze
image.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• This function is available for the host output only.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
1
Long press the [Tube/Gauze] button more
than 1 second.
• The highlighting level change dialog is dis-
played.
2
Change the image output settings on the
highlighting level change dialog.
• When the [Tube/Gauze ON & OFF] is pressed,
both the normal and highlighted images are out-
put during host output.
• When the [Tube/Gauze ON Only] is pressed,
only the highlighted image is output during host
output.
HINT
•••••••••••••••••••••••••••••••••••••
• The order of normal and highlighted image output can
be changed. For more details, contact Konica Minolta
technical representatives.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
6.4.24 Automatic 1×1 display
function
When examining with a 2×2 display screen or a 3×2
display screen, they can be changed to a 1×1 display
screen automatically when the exposed image is re-
ceived.
The following procedure describes an example of
what happens when, while having the screen display
set to 2×2, exposure is carried out with the automatic
1×1 display function enabled. The exposure order and
body parts are as follows.
(1) (2)
CHEST
_
Chest
Erect
_
Front
CHEST
_
Chest
Erect
_
LAT
* Numbers (1), (2) displayed on the screen are shown
for ease of explanation, and not displayed on the
actual screen.
1
Perform exposure (1).
• Set up the X-ray device before exposure. Per-
form exposure after checking the exposure set-
tings.
Press the exposure switch
(1) (2)