Konica Minolta CS-7 - Modifying the S Value;G Value; Zooming in and out

181
Chapter 6
6.7 Functions of the viewer screen
6.7.5 Modifying the S value/G
value
You can modify the S value/G value from the Viewer
screen.
1
Press [S/G Value].
• The control panel for adjusting the S value/G
value is displayed.
2
Adjusts the image.
• Pressing [ ] increases or decreases the
value step by step.
HINT
•••••••••••••••••••••••••••••••••••••
• Dragging the control panel slider or pressing [ ]
increases or decreases the S value/G value in mul-
tiples of the preset value. In addition, when you press
the [S/G] button on the control panel, the S value/G
value can be adjusted by dragging the image.
• Use the user tool to set the drag operation to in-
crease or decrease the S/G values and specify the
degree of change that can be obtained from [ ].
You can also select the setting so that the S/G values
can be adjusted by simply dragging the image or drag-
ging it using both mouse buttons without pressing the
[S/G] button.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
6.7.6 Zooming in and out
Zoom in or out from/to an image according to the fol-
lowing procedure.
1
Press [ZOOM+] or [ZOOM-].
2
Press any part of the image.
• Zooming in/out is displayed, centering on the
pressed part.
• Every time you press a part of the image, the
image is gradually zoomed in/out.