Konica Minolta CS-7 - Page 180

180
6.7 Functions of the viewer screen
Icon Functions
Switch between [ON] and
[OFF] of the masking area
display.
Specify a masking area by
automatically recognizing the
e󰀨ective image area.
Press any 2 points to specify a
square with a diagonal line that
connects the 2 points as the
size of the masking area.
Press any 4 points or more to
specify a polygonal masking
area.
Press any 3 points to specify a
round masking area.
Switch between [ON] and
[OFF] of the chest wall black-
ening process.
Resets operations performed
in the tab.
This is displayed in the specied
masking area. Drag to adjust
the size of the masking area.
Move the masking frame up,
down, left and right.
3
Press [Return] after change.
• Returns to the exposure screen.
HINT
•••••••••••••••••••••••••••••••••••••
• The masking area can be changed by directly drag-
ging the square mark on the frame border of the
masking area or its perimeter.
• After specifying a masking area, drag any point of the
masking area to change the shape of the masking
area.
• The results of masking recognition outside the expo-
sure field can be confirmed on the viewer screen or
the image display area of the exposure screen.
• Depending on the image information status, automatic
recognition of the exposure eld area may not be car-
ried out properly. In this case, please change the ef-
fective image area manually.
• The accuracy of masking can be increased by paying
attention to the following at exposure.
– Place protective equipment as parallel to the edge
of the exposure field as possible or place it so it
does not overlap the exposure eld edge.
– Make sure that objects (clothes or subject area
other than the target) other than the target body
part for exposure are not included in the image.
– Place the exposure target body part at the center
of the exposure eld as much as possible.
– When split exposure is performed, provide an inter-
val of at least 1cm between exposure elds before
exposure.
• When the fractional masking function is used on
REGIUS SIGMA/SIGMA2, the masking area may oc-
casionally be moved to the inside of the image.
•••••••••••••••••••••••••••••••••••••••••••••••••••••