76
4.1 Startup and shutdown
4.1.1 Startup of this device
Perform the following procedure when starting up this
device.
1
Turn on the power for X-ray devices, etc.
connected to this device.
2
Press the power switch on this device.
• Startup messages are displayed sequentially.
• Internal system initialization is performed while
the system startup screen is displayed.
• Upon completion of initialization, the initial
screen (patient registration screen or list screen)
is displayed, and this device is ready for opera-
tion.
Patient registration screen
List screen
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• When sharing a REGIUS among several units of this
device, start the unit with the JM installed first; after
conrming startup of this unit, start the other units.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT
•••••••••••••••••••••••••••••••••••••
• The software version is displayed on the system
startup screen. Initialization will be completed a few
minutes after turning on the power.
• A progress bar is displayed on the system startup
screen, indicating the status of the system initialization
process.
• During startup processing, if startup could not be
completed for any reason, an error message will be
displayed, and the system will transition to shutdown
processing.
• The patient registration screen will be displayed by de-
fault. For the second startup and thereafter, the screen
displayed at the last shutdown will be displayed.
•
In cases where a device like REGIUS is connected to
this device and the power is linked, when the power for
this device is turned on, the power for connected de-
vices is also turned on.
•
The position of the power switch varies according to the
personal computer you are using. Refer to the product
operation manual for details.
•••••••••••••••••••••••••••••••••••••••••••••••••••••