330
7.18 Checkup mode
4
Turn [Daily Reset] and [Auto Checkup]
[ON] and [OFF], as necessary.
5
Select the preset used.
6
Press [OK].
• The display returns to the system monitor
screen.
7
Press [Close].
• The display returns to the initial screen.
• When serial numbers are automatically issued,
the list screen or the patient registration screen
is displayed. Press [Perform] to start the expo-
sure in checkup mode.
7.18.4 Exposure in checkup
mode
The following describes the procedure for performing
exposures in the checkup mode.
Before starting the exposure, refer to
"7.18.3 Starting
checkup mode" to make necessary preparations for
the checkup mode.
The following procedures vary depending on whether
the auto examination start function is to be used, and
also whether the Exam. Tags are already set for the
preset used.
z
When the Auto Checkup is turned ON and
the Exam. Tags are set
The following describes the procedure when [Auto
Checkup] is turned [ON] and the Exam. Tags are set
for the preset used.
1
Display the Patient registration screen or
List screen.
• Check that the automatic issuing worked cor-
rectly.
To Next Page
Loading...
Need help?
General
