Konica Minolta CS-7 - Image Combination

279
7.9 SIGMA stitching exposure
Chapter 7
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• If the image rotation settings have not been specied
with the SIGMA stitching Exam. Tags, rotate the im-
ages before combining them.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT
•••••••••••••••••••••••••••••••••••••
• You can also specify the reading sequence in the or-
der list. Set the upper stage of the Reina buckies for
the rst exposure, and then press the exposures se-
quentially.
• If you press the exposure conditions display area
where the reading sequence of the examinations is
specied, the specied reading sequence is cancelled.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
7.9.3 Image combination
You can automatically or manually combine the stitch-
ing images exposed using the Reina buckies. The fol-
lowing procedure describes an example of combining
3 images.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• If SID is 1.7m or less, it may be necessary to adjust
the combination positions manually.
• Adjust the combination position by using the markers
as supplementary standards in addition to body parts
of the subject.
It is also recommended that you arrange the measure
in the combined image part during exposure to sim-
plify the conrmation of the combined parts.
• In stitching exposure, when plates overlap and are ar-
ranged so that there is no image loss in each plate's
boundaries, there might be a slight gap in the marker
position because of a minute di󰀨erence in magnica-
tion. After taking this into account, conrm the combi-
nation position through the marker.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
1
Select the images to be combined.
• Select the images to be combined from the or-
der list and press [ ] or [ ].
• The selected images are displayed in the com-
bined image display area.
• If you pressed [ ], continuously select the
associated images (second and third).
HINT
•••••••••••••••••••••••••••••••••••••
• [ ] and [ ] can be pressed only when the set
key for stitching exposure has been selected.
•••••••••••••••••••••••••••••••••••••••••••••••••••••