Konica Minolta CS-7 User Manual

145
Chapter 6
6.4 Functions of the exposure screen
6.4.12 Status of devices
The device status can be displayed in the image dis-
play area where no exposed image is displayed.
1
Set focus on unexposed image display area.
• Status of devices is displayed.
z
Meaning of the device status
When using an DR Detector
Display Description
Entry...
Registering.
This is displayed while the DR Detector
is being registered in this device through
roaming.
Preparing
Waiting for switch to response mode and
reset to nish.
Connecting... Connecting.
Processing...
Processing.
This is displayed when images are being
read.
Starting
Status after turning on the DR Detector
until exposure is ready.
Waiting
Waiting. Selecting the frame in which
"Waiting" is displayed shifts the mode to
"Ready".
Sleep Mode
The DR Detector is sleeping. Selecting the
frame in which "Sleep Mode" is displayed
shifts the mode to "Ready".
Ready Exposure is ready.
Display Description
Error
Error is occurring.
Panel not
detected
Status where exposure conditions for
examination are not set yet, and no DR
Detector is inserted in either wall stand and
table.
Please check
panel
For reasons such as no DR Detector is in-
serted in the wall stand and table, or power
is o󰀨, exposure is not possible with the DR
Detector.
Charging...
This is displayed when the DR Detector is
being charged due to a low battery level.
Please
Charge
This is displayed when the DR Detector's
battery level is low but the DR Detector is
not being charged.
Reading…
Images are being read.
HINT
• This is displayed when performing
exposure in Aero Sync mode.
Waiting for
permission
Waiting for exposure permission.
Pressing [AeroSync] shifts the mode to
"Ready".
HINT
• This is displayed when performing
exposure in Aero Sync mode.
Waiting to
start shooting
Waiting to start shooting.
Pressing [AeroSync] shifts the mode to
"Ready".
This is displayed when the AeroDR power
management level is set to [3], [4] or [5].
HINT
• This is displayed when performing
exposure in Aero Sync mode.
Stitching
System is not
connected
This is displayed when this device is not
connected to the AeroDR Stitching Unit.
Check the connection.
Please do the
height detec-
tion
This is displayed when the height of the
AeroDR Stitching Unit is not detected.
Perform height detection.
Please detect
radiation eld
This is displayed when the irradiation eld of
the AeroDR Stitching Unit is not detected.
Perform irradiation eld detection.
Exposed
This is displayed when the number of
stitching exposures is less than the sched-
uled number.
When using a CR cassette
Display Description
Waiting for
preparation
Status where cassettes cannot be loaded.
This is displayed when CR cassettes can-
not be read continuously.

Konica Minolta CS-7 Specifications

General

Brand	Konica Minolta
Model	CS-7
Category	Measuring Instruments
Language	English