Konica Minolta CS-7 - Logoff; Switch of Operators

80
4.2 Login control
4.2.3 Logo󰀨
Logo󰀨 is performed when switching users and so forth.
Press [
] to display the tool bar that is displayed at
the bottom of the screen, then follow the procedure
described below to log o󰀨.
1
Press [Logo󰀨].
• Logging o󰀨.
• After logo󰀨, the login screen is displayed.
HINT
•••••••••••••••••••••••••••••••••••••
• [Logo󰀨] cannot be pressed until an image is acquired
from a reader device and the actual image is dis-
played.
• When [Logoff] is pressed during an examination, a
message stating that the examination is paused is dis-
played. Press [OK] on the conrmation screen to log
o󰀨, pausing the examination.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
4.2.4 Switch of operators
When 2 or more operator names are registered, their
names can be switched. Operator names can be
switched only when the automatic login function is en-
abled.
1
Press [Operator] in the application bar.
• The operator name selection screen is dis-
played.
2
Press the operator name to switch to it.
• The operator names are switched.
HINT
•••••••••••••••••••••••••••••••••••••
• When using certain settings, the login user name and
the operator name can be synchronized.
•••••••••••••••••••••••••••••••••••••••••••••••••••••