385
10.1 Types of error codes and recognition methods
Chapter 10
10.1.2 Recognition method for error codes
The initial letters have been decided for each type of error code. When an error message has been displayed, identify
the type of error in accordance with the ow and check the error description and the countermeasures in each item.
Error code
"G" is displayed as
the initial letter of the
error code.
Check "10.2.4 AeroDR Interface
Unit2/AeroDR Generator Inter-
face Unit/AeroDR Generator
Interface Unit2/AeroDR Por-
table RF Unit/AeroDR Portable
RF Unit2 errors" and perform
the countermeasures.
AeroDR Portable RF Unit2 is
used.
Check the initial letters of the error code.
"C2" is displayed as
the initial letters of the
error code.
"C3" through "C7" are
displayed as the initial
letters of the error code.
"F" is displayed as
the initial letter of the
error code.
Check "10.2.1 Communication
errors" and perform the coun-
termeasures.
Check "10.2.2 Software errors"
and perform the countermea-
sures.
Check "10.2.3 DR Detector er-
rors" and perform the counter-
measures.
The AeroDR Generator Interface
Unit is used.
The AeroDR Interface Unit2 is
used.
The AeroDR Portable RF Unit is
used.
"S" is displayed as
the initial letter of the
error code.
Check "10.2.5 AeroDR Stitch-
ing System errors" and per-
form the countermeasures.
A numerical value,
"CAS", "SIG", etc. is
displayed at the bigin-
ning of the error code.
Check "10.2.6 REGIUS series
errors" and perform the coun-
termeasures.
The AeroDR Generator Interface
Unit2 is used.