Konica Minolta CS-7 - Exposure Preparations; New Registration of Patient; Information

210
7.2 Exposure with AeroDR Portable RF Unit2
7.2.3 New registration of
patient information
New registration of patient information is performed
with the patient registration screen. Select the
[PatientReg.] tab on the initial screen to display the pa-
tient registration screen.
1
Press the column for the patient ID.
2
Press the input panel, and input the patient ID.
3
Press [Enter].
4
Input patient name, sex and date of birth.
• After each inputting item, press [Enter].
• If you press [Enter], the cursor will move to the
next item.
HINT
•••••••••••••••••••••••••••••••••••••
• If the length of an entry exceeds the dimensions of the
display pane of the item or if the entry spreads across
multiple lines, the long-sentence comment pop-up but-
ton [
] is displayed.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
7.2.2 Exposure preparations
The exposure preparation of the AeroDR Portable RF
Unit2 is performed according to the following proce-
dure.
1
Prepare each device to perform exposure.
• For information on how to prepare each device
to perform exposure, refer to "AeroDR Portable
RF Unit2 Operation Manual".
2
Turn each device on.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• After the access point has started, it may take some
time to establish a wireless connection.
• To register the DR Detector, connect this device to the
AeroDR Portable RF Unit2 in wired mode.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
3
Turn the mobile X-ray device on.