24
1.2 Safety precautions
1.2.4
Precautions regarding care
and maintenance of this device
WARNING
• Do not remove the lithium batteries.
• Turn the power o and remove the power plug from
the wall outlet.
CAUTION
• Perform the maintenance and inspection periodi-
cally. Also, contact Konica Minolta technical repre-
sentatives for cleaning of the inside.
• Immediately after turning the power o, be careful
of hot components inside this device.
• Install the power cable, interface cable, etc.
securely.
• Do not rub or strike this device with hard objects as
it will cause damage.
1.2.5 Precautions regarding
CD/DVD use
WARNING
• The optical head of the CD/DVD device discharges
a laser, so take care not to look in the object lens of
the optical head.
CAUTION
• Take the following precautions to prevent reading
errors etc.
– Do not subject to impact.
– Do not touch disk surfaces.
– Place in cases when storing.
– Do not place in locations with a lot of dust.
– Do not place in locations with high temperature
and high humidity.
– Do not place in direct sunlight.
• Attach labels to CD/DVD surfaces and cases so
that the recorded content can be identied.
• The types of media supported by this device are
CD-R and DVD-R only. Also, please note that it is
possible that when saving on media other than the
following, writing errors or reading errors may oc-
cur. Please be forewarned.
– TDK Co. CD-R 1-48 speed supported <for data>
– Mitsubishi Kagaku Media Co. CD-R 1-48 speed
supported <for data>
– Mitsubishi Kagaku Media Co. DVD-R 1-16
speed supported <for data>
• If dust adheres to the object lens of the optical
head in the CD/DVD drive, it is possible that writ-
ing errors and reading errors may occur. In such
case, remove the dust with a commercial DVD lens
cleaner.