Konica Minolta CS-7 - How to Release the Lock on; The Exposure Screen

9.1 Various problems and countermeasures
382
9.1.7 How to release the lock
on the exposure screen
After operating the exposure switch of the X-ray de-
vice, the screen sometimes remains locked without
displaying the exposure image ([
] and [
] can-
not be pressed).
When this condition occurs, perform the following op-
eration.
1
Again press only the rst stage of the ex-
posure switch, and release it.
• The screen lock is released, and the screen op-
eration and operation of the exposure switch are
enabled.
• Make sure "Ready" is displayed in the work area
of the exposure target, and expose again.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• In the above operation when the screen lock is re-
leased, X-rays are not actually exposed, rather it is a
state awaiting exposure.
•••••••••••••••••••••••••••••••••••••••••••••••••••••