Konica Minolta CS-7 - Change of the ROI Area

177
Chapter 6
6.7 Functions of the viewer screen
Icon Functions
Switch between [ON] and
[OFF] of ROI mode.
Press any 2 points to specify
the square with a diagonal line
that connects the 2 points as
the size of the ROI area.
Adjust the width of the ROI
area. The width changes every
time you press these buttons.
Adjust the height of the ROI
area. The height changes every
time you press these buttons.
Switch between the displays
of 2 ROIs when the image pro-
cessing parameter has 2 ROIs.
Resets operations performed
in the tab.
3
Press [Return] after change.
• Returns to the exposure screen.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• When the ROI area is changed, the auto gradient pro-
cess is performed again, and the optimized image is
displayed.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT
•••••••••••••••••••••••••••••••••••••
• E/F/HS parameters can be changed individually.
• The results of the changed parameter, such as E/F/
HS, are automatically stored, and can also be reect-
ed in following exposures.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
6.7.2 Change of the ROI area
This device will automatically recognize the ROI
and display in the image area. The ROI area can be
changed manually as necessary.
1
Press [ROI Adjustment].
• The viewer screen is displayed.
2
Change the ROI area.
• When an image is pressed in any location, ROI
moves with the pressed part as the center.