167
Chapter 6
6.5 Exposure Screen ([Output] Tab) Functions
• After selecting the images, select [ ]
from [Format] following Steps 4 to 5, and change
the [Film Size], [Direction], and [Output Type].
• Set the [Film Size], [Direction], and [Output
Type] the same as the selected image in the rst
sheet.
7
Press [ ] of the rst image to be out-
put.
• The icon will change to [ ] which denotes
pair waiting status.
8
Press [ ] of the 2nd image to be out-
put.
• A conrmation screen is displayed.
9
Press [OK].
• The images are output to the printer, and [ ]
is displayed in each image display area.
• [ ] changes to [ ] indicating that output is
done.
IMPORTANT
••••••••••••••••••••••••••••••••••••
• When outputting in AB format, be careful of the follow-
ing.
– Images are outputting as a pair only when the for-
mat, lm size, and lm orientation of the 2 images
to be output are the same. If there is no matching
image, then only 1 image is output.
When there is a matching pair
To Next Page
Loading...
