Konica Minolta CS-7 - Page 203

203
7.1 Exposure with AeroDR Portable RF Unit
Chapter 7
4
Perform exposure.
• Congure the portable X-ray device settings and
check the exposure setting before making an
exposure.
Press the exposure switch
• The exposed image is displayed in the image
display area.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• When performing an exposure, stay away from the pa-
tient as far as possible before pressing the exposure
switch.
• Do not let the DR Detector vibrate or receive shock
until the exposed image is displayed.
• If an image is displayed when an exposure is not per-
formed, this may be a detection error due to noises,
etc. Perform rejected image (deletion of images) and
repeat exposure.
• If you have performed an exposure when "Ready" was
not displayed, repeat an exposure after approximately
one minute.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
5
Adjust the image.
• After exposure, adjust the image as required.
6
Press [ ].
• The exposure is completed, and the display re-
turns to the initial screen.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• When consolidating image adjustment, press [ ] to
pause the examination and return to the initial screen.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
7
When exposure is nished, turn the Aero-
DR Portable RF Unit o󰀨.
• Turn off the power switch of the AeroDR Por-
table RF Unit, and check that the power LED
(green/orange) is o󰀨.
• For shutdown operation of the AeroDR Portable
RF Unit, refer to the "AeroDR Portable RF Unit
Operation Manual".
HINT
•••••••••••••••••••••••••••••••••••••
• Image adjustment can be done on the exposure
screen. However, if a more advanced image adjust-
ment is required, perform image adjustment on the
viewer screen. For details on the viewer screen, refer
to "6.7 Functions of the viewer screen".
• When moving the exposure location, turn off the
AeroDR Portable RF Unit. After moving the exposure
location, perform the procedure again from step 1.
• It is all right to keep power of this device and the DR
Detector on.
•••••••••••••••••••••••••••••••••••••••••••••••••••••