Konica Minolta CS-7 - Page 22

22
1.2 Safety precautions
WARNING
• Image processing functions must be used by quali-
ed persons with specialized knowledge of image
diagnosis equipment and image processing. In ad-
dition, su󰀩ciently conrm the results of image pro-
cessing.
• Do not perform diagnosis with the images displayed
on this device.
• Risk of misidentification of patients may occur if
modifications to patient information for examina-
tions or examination information acquired from a
higher system such as a Radiology Information
System (RIS) are made. When the information is
modified, notify the system administrator of the
modification without delay, and in addition, make
sure that the patient information and/or examination
information are correctly modied on output devices
such as PACS to which this device sent the image
information and examination information.
• Konica Minolta will not be liable for the loss of im-
portant data such as patient information arising
from the introduction of this system. Important data
require separate assurance of security, backup, etc.
• When lightning is likely to occur, stop work and
unplug the power plug from the wall outlet. When it
thunders before unplugging the power plug do not
touch the device, including any of the cables. Doing
so may cause a re or electric shock.
• If there is any smoke, odor, or abnormal sound, it
may cause a re if use is continued, so immediately
turn the power switch off, unplug the power plug
from the wall outlet, and contact Konica Minolta
technical representatives.
• Take the following precautions when using this de-
vice and software.
– Konica Minolta or a contractor designated by
Konica Minolta will install the software of this de-
vice.
– Do not disassemble or modify this device.
– Do not connect any devices that were not pur-
chased from Konica Minolta.
– Do not install software purchased from other
companies.
– Do not uninstall software that has already been
installed.
– Take precautions to prevent infection from com-
puter viruses.
– Do not change the setting for the OS (operating
system), or delete folders or les.
– Do not operate Windows Explorer unless speci-
ed.
– Do not use the DVD drive for other purposes.
– Confirm that the hard disk access lamp is out
before removing disks.
– Do not turn the power switch o󰀨 or pull out the
power cable while the system is operating.
WARNING
• Take note of the following to reduce the risk of re,
electric shock, or electrical leakage:
– Always use the specied cables such as a pow-
er cable.
– Use wall outlet with the correct rating as a power
source.
– Connect the power plug to the wall outlet prop-
erly without any slack.
– Use a power source with a ground wire.
– If you do not plan to use this device for an ex-
tended period of time, unplug the power plug.
– The supplied power cable is dedicated for this
device, so do not use it elsewhere.
– Avoid exposure to liquids such as water.
– Make sure that foreign material, such as pieces
of metal or wires, does not get inside.
– Do not handle the power plug with wet hands.
– Do not let dirt or dust adhere to the power plug.
– Do not use extension cables.
– Do not place many loads on a single electrical
outlet.
– Do not damage the power cable. Also, do not
use damaged cables.
– Do not block the ventilating openings.