Konica Minolta CS-7 - Page 248

248
7.5 Manual stitching exposure
2
Press [Stitching].
• The viewer screen (for stitching combination po-
sition adjustment) is displayed.
3
Select the frame which will adjust the im-
age combination position.
• Focus is applicable to the frame so you will be
able to make adjustments.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• Adjust the density of each image in this step.
• If there are three images, adjust the density of the
upper and lower images to that of the center image.
If an image used as the density standard is changed,
adjust the density so that it suits the changed image.
• If there are two images, adjust the density of the upper
image to that of the lower image. If the upper image is
used as the density standard, adjust the density of the
lower image based on the upper image.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT
•••••••••••••••••••••••••••••••••••••
• For the frame display format, 1×1, 2×1, and 2×2
display options can be selected.
• A 2×2 frame display can only be selected when
combining 3 images.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
4
Adjust the image combination position.
• For details on how to operate the viewer screen
(for stitching combination position adjustment),
refer to
"7.5.1 Screen structure".
• Select another frame and adjust the combina-
tion position as needed.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• Even if the displayed transmittance of the overlap por-
tion is modified during the adjustment, it will not be
reected in the output image.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
5
Once all combination positions are ad-
justed, press [Apply].
• The image combination position is conrmed.