252
7.6 Auto stitching exposure with AeroDR Detector
Number Name Functions
(2) Overlap button
Changes the plate overlap
sequence. Every time you
press the button, the plate
overlap sequence is se-
quentially changed and the
display of the overlap button
is changed. The changed
overlap sequence is also
reected in the output image.
:
Interchanges the plate
overlap sequence (middle
and bottom).
:
Interchanges the plate
overlap sequence (top and
middle).
When two plates are used,
only [ ] is displayed.
(3) Adjust button
Displays and hides the stitch-
ing adjustment panel.
(4) Proportion button
Changes the displayed trans-
mittance of the overlapped
portion. Pressing this button
sequentially changes the
transmittance. A modied
transmittance is not reected
in the output image.
(5) Reset button
Resets the position of the
moved image and the
changed density to return
them to their initial states.
(6) Full preview
All images to be combined
are displayed.
(7)
Part correction
button
Adjust the density of the im-
ages by pressing [
] or
dragging the bar.
(8)
Move/rotate but-
ton
Moves the position of select-
ed images and adjusts their
angles.
:
image position is moved
toward each direction.
:
image angles are adjusted.
(9)
Magnication Ra-
tio button/Magni-
cation Ratio bar
Display images are magnied/
shrunk by pressing [
] or dragging the bar.
(10) Apply button
Applies the adjusted image
combination position.
HINT
•••••••••••••••••••••••••••••••••••••
z
Moving/rotating an image during image
combination
• For image movement/rotation, the lower image be-
comes the work image. The movement/rotation action
is as follows.
Moving
[ ][ ][ ][ ]:
Moves the image to direction
pressed
The image can also be moved by
dragging the center of the image
(horizontal stripe portion).
Rotating
[ ]: Lowers the upper left
edge of the image
[
]: Raises the upper left
edge of the image
[
]: Lowers the upper right
edge of the image
[
]: Raises the upper right
edge of the image
If you drag the left or right area of the image (horizontal
stripe portion) vertically, you can move the upper edge
up or down in the direction you are dragging it. If you
drag it horizontally, you can move the image horizon-
tally.
z
Linking 3 images
• When combining 3 images, the lower image will also
move/rotate if the central image is moved/rotated.
To Next Page
Loading...
