Role Instance
Use the (config-role) instance to configure Role related configuration commands. To
navigate to the
config-role instance, use the following commands:
RFSwitch(config)#role <rolename> <rolepriority>
RFSwitch(config-role)#
For more information on the role command, see role on page 5-91.
26.1 Role Config Commands
The following table summarizes config-role commands:
Command Description Ref.
ap-location Sets the AP location configuration page 26-3
authenticati
on-type
Sets the authentication type configuration page 26-5
encryption-
type
Sets the encryption type page 26-6
essid Sets ESSID configuration for role based firewall page 26-8
group Sets role group properties page 26-9
ip Sets IP configuration properties page 26-10
mac Sets MAC configuration properties page 26-11
To Next Page
Loading...
