Motorola RFS Series

Wireless Instance
20-93
20.1.46 service
 Wireless Configuration Commands
Invokes service commands to troubleshoot or debug (config-wireless) instance
configurations
For more information, see Chapter 2, Section 2.1.5 service on page 2-7.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
service [clear|show|smart-rf|wireless]
service clear wireless mobile-unit association-statistics
service show [cli|radio-neighbor|smart-rf|wireless]
service show cli
service show cli radio-neighbor mu <MAC>
service show smart-rf [debug-config|sensitivity]
service show smart-rf debug-config
service show smart-rf sensitivity [mu|pattern|rates]
service show smart-rf sensitivity mu {[<0-8192>|<MAC>]}
service show smart-rf sensitivity pattern [pattern-11a|
pattern-11b|pattern-11bg|pattern-2-mbps]
service show smart-rf sensitivity rates <rate-flag>
service show wireless [ap-history|buffer-counters|
enhanced-beacon-table|enhanced-probe-table|group|
group-stats|legacy-load-balance|mu-cache-buckets|
mu-cache-entry|mvlan|radio|radio-cache-entry|
radio-hash-buckets|snmp-trap-throttle|vlan-cache-buckets|
vlan-cache-entry|waiting]
service show wireless [buffer-counters|group-stats|
legacy-load-balance|mu-cache-buckets|radio-hash-buckets|
snmp-trap-throttle|vlan-cache-buckets]
service show wireless ap-history {<MAC>}
service show wireless enhanced-beacon-table [config|report]
service show wireless enhanced-probe-table [config|report]