Common Commands
2-147
2.1.60 firewall
Priv Exe Mode
Displays wireless firewall
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
show firewall [config|dhcp|flow]
show firewall [config|dhcp snoop-table|flow timeouts]
Parameters
Example
RFSwitch#show firewall
RFSwitch#
RFSwitch#show firewall config
RFSwitch#
RFSwitch#show firewall flow
RFSwitch#
firewall [config|dhcp
snoop-table|
flow timeouts]
Displays firewall configuration information.
• config – Displays Configuration
• dhcp snoop-table – Displays Dhcp snoop-table entries
• flow timeouts – Displays firewall flow
• timeouts - Flow timeout configuration
NOTE: For information on the ‘firewall’ command in Global Config
mode, refer to firewall on page 5-135.
To Next Page
Loading...
