Motorola RFS Series

Motorola RF Switch CLI Reference Guide
17-4
17.1.2 deny
 MAC Extended ACL Config Commands
Specifies packets to reject
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] {[dot1p|rule-precedence|type|vlan]}
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] dot1p <0-7> {rule-precedence|type}
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] rule-precedence <1-5000>
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] type [8021p|<1-65535>|aarp|appletalk|apr|ip|
ipv6|ipx|rarp|wisp] {rule-precedence <precedence>}
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] vlan <1-4094> {rule-precedence|type}
NOTE: Use a decimal value representation of ethertypes to implement
a permit/deny/mark designation for a packet. The command set for
Extended MAC ACLs provide the hexadecimal values for each listed
ethertype. The switch supports all ethertypes. Use the decimal
equivalent of the ethertype listed for any other ethertype.