Wireless Instance
20-89
20.1.44 self-heal
Wireless Configuration Commands
Configures self healing values
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
self-heal [interference-avoidance|neighbor-recovery]
self-heal interference-avoidance [enable|hold-time
<30-65535>|retries <0.0-15.0>]
self-heal neighbor-recovery [action|enable|neighbors|
run-neighbor-detect]
self-heal neighbor-recovery action [both|none|open-rates|
raise-power] radio [<1-4096>|<radio-list>]
self-heal neighbor-recovery neighbors <1-4096> [<1-4096>|
<radio-list>]
self-heal neighbor-recovery run-neighbor-detect
Parameters
interference-avoidance Interference avoidance configuration.
enable Enables/disables interference avoidance.
hold-time <30-65535> The number of seconds to disable interference avoidance
after a detection. This prevents a radio from changing
channels continuously. Set the hold-time between 30-
65535 seconds.
retries <0.0-15.0> Defines the average number retries (0-15) causing a radio to
re-run auto channel selection.
neighbor-recovery Invokes neighbor recovery configuration commands.
To Next Page
Loading...
