RTLS Instance
Use the (config-rtls) instance to configure Real Time Location System (RTLS)
parameters.
To navigate to this instance, use the command
RFSwitch(config)#rtls
RFSwitch(config-rtls)#
21.1 RTLS Config Commands
This summarizes config-rtls commands:
Command Description Ref.
aeroscout Configures aeroscout parameters page 21-2
clear Clears locationing information page 21-3
clrscr Clears display window page 21-4
end Ends the current mode and moves to EXEC mode page 21-5
espi Configures ESPI parameters page 21-5
exit Ends current mode and moves to the previous mode page 21-6
help Description of the interactive help system page 21-6
ekahau Configures ekahau parameters page 21-7
To Next Page
Loading...
