Wireless Instance
20-53
20.1.29 load-balance

Wireless Configuration Commands
Configures the user load balance mode
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
load-balance [by-count|by-throughput]
Parameters
Example
RFSwitch(config-wireless)#load-balance by-throughput
RFSwitch(config-wireless)#
by-count In load balance by user count, the load on the radio is
measured by the number of MUs associated. The desired
balance is to have equal number of MUs on the radios in the
group. By default, the load balance is configured for
by-count when the switch boots up with factory default
configuration.
by-throughput In load balance by radio throughput (threshold 1 Mbps) the
load on the radio is measured by the current average
throughput rate. The desired balance is to have similar
wireless traffic on the radios in the group.
To Next Page
Loading...
Need help?
General
